|Model||Bag Width||Bag Length|
|Servo Mini Linear Machine 150||90mm ~ 150 mm||90mm ~ 210 mm|
|Servo Mini Linear Machine 210||120mm ~ 210 mm||150mm ~ 310 mm|
|Servo Mini Linear Machine 260||120mm ~260 mm||150mm ~ 350 mm|
|Pneumatics component Airtac from Taiwan;|
|Omron PID Temperature Controller;|
|Delta 10 inches from Taiwan;||Piab Vacuum Generator From Sweden;|
* Panasonic Servo Motor Drive And Screw Shaft track to do the transverse Moving;
Easy Operation, No Key inserted;
check and monitor a safety system;
either allow the machine to start or execute commands to stop the machine;
More friendly like Pad operation;
Hand Wheel to adjust pouch magazine for different bag width;
2.Safety Infeed hopper
* Part A is Fixed.
* Part B is inserted up and down into the bag to guide to discharge product.
3.Grippers Holding Position Function
Catch the pouch mouth where is sealed area on the pouch as the picture shows “H” The Grippers would be held the bag for filling and straight it up after filling by same pouch position. So The product would be filled more than normal pouch machine because of grippers’ working position.
Convexity Product Settle
* It would be moved up and down to flap Pouch Bottom to settle and tight the product.
It is better than the flat plate.
* The product settle should be worked during the filling. Most of the filling is center on middle of the pouch.
So, the product would be built the ‘little mountain’. It is better to have the convexity product as the pictures show.
When it is flapped the filled pouch bottom by up and down movement, the product would be spread around inside of the pouch.
KAF 350 Auger Filler
* Dosing Technique: By auger
* Filling Range:≤1kg
* Accuracy:±0.3-1%(depend on product property and filling weight)
* Hopper Size:30L
* Motor: single-phase 220V, 50Hz/60Hz
* Servo Motor:1000W
* Agitating Motor: 200W
* Level Sensor: Tuning Fork;
* No Cleaning Dead Point; High hygiene application;
* Weight Checker and Feedback Control System
It is helpful for the operator to set the right weight when the powder weight is required;
* Max Blowing: 84m3/h
* Power: 400W
* Voltage: Single-phase 220 50Hz;
* Capacity: 6-8m3/h;
* Discharge Height: 2300mm;
* Hopper Size: 230L(round);
* Voltage: three-phase 220V 50Hz / 60Hz;
* Feeding Motor’s Power:3000W;
* Vibrating Motor’s Power: 120W;
* Material: SUS304;
* Tooless to take down the Conveyor to do the Clean;
* Machine Weight: 320Kg;
* Spec: Φ5X60X60;
* Material：SUS 304;
* with safety alarm (in the hopper);
Stainless Steel Lid;
* Spec: Φ1000;
* Material：SUS304, thickness: 1.5mm;
* with glass window on the top;