KEEPACKAGING CO., LTD.
contact sales at jujiao.
|Model||Bag Width||Bag Length|
|Servo Mini Linear Machine 250||120mm ~ 250 mm||150mm ~ 350 mm|
|Servo Mini Linear Machine 260||140mm ~ 260 mm||150mm ~ 500 mm|
Pneumatics component Airtac from Taiwan;
|Omron PID Temperature Controller;|
|Omron Safety Relay;|
Piab Vacuum Generator From Sweden;
|Delta 8inches Control Panel;|
* Panasonic Servo Motor Drive And Screw Shaft track to do the transverse Moving;
Easy Operation, No Key inserted;
check and monitor a safety system;
either allow the machine to start or execute commands to stop the machine;
More friendly like Pad operation;
Hand Wheel to adjust pouch magazine for different bag width;
2.Safety Infeed hopper
* Part A is Fixed.
* Part B is inserted up and down into the bag to guide to discharge product.
3.Grippers Holding Position Function
Catch the pouch mouth where is sealed area on the pouch as the picture shows “H” The Grippers would be held the bag for filling and straight it up after filling by same pouch position. So The product would be filled more than normal pouch machine because of grippers’ working position.
Convexity Product Settle
* It would be moved up and down to flap Pouch Bottom to settle and tight the product.
It is better than the flat plate.
* The product settle should be worked during the filling. Most of the filling is center on middle of the pouch.
So, the product would be built the ‘little mountain’. It is better to have the convexity product as the pictures show.
When it is flapped the filled pouch bottom by up and down movement, the product would be spread around inside of the pouch.