Model | Bag Width | Bag Length | |
MDP-S | 120mm ~ 260 mm | 120mm ~ 300 mm | |
Electronic: | Mitsubishi PLC | Pneumatic: | Pneumatics component Airtac from Taiwan; |
Omron PID Temperature Controller; | |||
Delta 10 inches from Taiwan; | Piab Vacuum Generator From Sweden; |
* Panasonic Servo Motor Drive And Screw Shaft track to do the transverse Moving;
1.Safety Protection
IP66 Application;
Easy Operation, No Key inserted;
check and monitor a safety system;
either allow the machine to start or execute commands to stop the machine;
More friendly like Pad operation;
Easy View;
Hand Wheel to adjust pouch magazine for different bag width;
2.Safety Infeed hopper
* Part A is Fixed.
* Part B is inserted up and down into the bag to guide to discharge product.
3.Transverse Moved Bars on Servo Mini
Please check the photo about the transverse Moving bars which would be moved the filled bag to the sealing station. It would be dipped the U shaped to catch the straight up filled pouch to be moved. This bar is helpful for different application like powder, Liquid.
4.Important Feature Grippers’ working Position
Servo Mini’s Grippers
* The Servo Mini Machine is catch the area which is above the zipper. It would be filled more up to zipper area. Its filling area is about 10 + 25mm=35mm. Like the picture.
Especial for the powder application, when the filled bag is straight up after filling, it is easy to push out the powder to build the dusty.
The dusty would be polluted the pouch sealed area. The sealing quality would be leakage or broken.
So The product would be filled more by Servo Mini machine than normal pouch machine because Grippers’ holding position.
Current Pouch Machine’s Grippers
* The normal pouch machine is held the position as the photo.
A is Height of the gripper. Its minimum Height is 10mm.
B is Height of the zipper opener and sealing area. Its Minimum height is 25mm;
When the bag is filled, the product level should be at least 25mm lower than the gripper position B. Or else, when the bag is straight up by the grippers, the product would be squeezed out. So It means there is about 10 + 25 + 25=60mm could not be filled for the pouch;
Convexity Product Settle
* It would be moved up and down to flap Pouch Bottom to settle and tight the product.
It is better than the flat plate.
* The product settle should be worked during the filling. Most of
the filling is center on middle of the pouch.
So, the product would be built the ‘little mountain’.
It is better to have the convexity product as the pictures show.
When it is flapped the filled pouch bottom by up and down movement, the product would be spread around inside of the pouch.
OUR SERVICE |
Pre-Sales Service:
1. Machine testing for free.
2. According to customer's inquiry, our engineer, sales, designer will provide the suitable packaging solution, even you are new factory.
After-Sales Service:
1. Provide set of video for installation, setting, maintenance.
2. Provide tool case with spare part for each machine FOR FREE.
3. Provide a 2-YEARS WARRANTY.
4. Engineer available to service machinery oversea.
The granule packing machine is suitable for all kinds of grain material, sheet material, strip material and abnormity material which such as candy, melon seeds, chips, peanut, nutlet, preserved fruit, jelly, biscuit, confect, camphorball, currant, almond, chocolate, filbert, corn, Potato Crisps, pet foodstuff, dilatant foodstuff, hardware and plastic can be weighed by the ration.
Copyright © 2019 KEEPACKAGING CO., LTD.| All Rights Reserved Design